rickst29

If that 12-volt wire goes directly to Battery +, it must be separately fused. Less important, the jack's ground wire should be bridged...

The battery shown lower down within IMG_0391 is the "first" battery in your series pair, and you have a large black wire accomplishing...

You're correct, leave the hitch connected. I meant to speak of only the the WDH tension bars, and I wrote the post in a hurry. I...

I would argue that not only should you NOT disconnect the TM from the TV, but you should in fact make a point to leave them connected...

Wow! I didn't realize that Rick and I have a number of very different opinions and experiences on how to change a tire! We are both...

You won't need to raise both shells all the way up, but you will need about 6" of rise. You must absolutely NOT use the corner levelers...

Years ago I found a great transmission shop in Phoenix. I have used them several times, always with good results. They know about my...

I mounted a 400W panel on the rear shell but elected to drill and seal so that there was a mechanical connection rather than tape. I...

Regular steel and aluminum has a lot of that effect, but stainless is more immune. SS fender washer can be painted to match the...

David, VHB tape works great for flexible panels, and it is pretty good for panels mounted front-to-back on the larger "front" shell. But...

The bees setup shop while their camper wasn't being used but it wasn't discovered until they tried to use the furnace. Not good. I've...

I'll return them to Amazon (unopened) and probably buy some stainless mesh to make a flat version.

Like Bill, I run with a heavy hitch - about 13% works for me. But I travel in big mountains, sometimes with grades reaching (and even...

And that, of course, is the proper answer. The accepted rule, given on every camper and trailer site, is that the tongue weight should...

I should have no problems staying within the weight limits. It's more a question of balance with the tank being behind the axle on the...