Bed Support Hardware?

[usafabronco]

Can somebody please post a picture or diagram of what the bed support hardware is supposed to look like where it meets the track on the underside of the bed? I have some rusty and obviously incorrect hardware that has never been tight since I've bought the used TM. A parts break-out would be very helpful too. I've looked through the TM Parts Manual several times without being able to find the part numbers I need.

Thanks!

[Kidkraz]

USAF?? and a bronco fan to boot. Take a look in my albums, I have some pictures of the bed there. Not sure it will be exactly what your looking for, but it's might help you some. My TM is open and I should be able get you some pictures tomorrow of the rollers.
By the way, I'm retired AF.

[usafabronco]

I am an AF guy, currently stationed at Barksdale AFB on staff. I can't wait to play with planes again! My college car was a 1976 Ford Bronco, hence the "bronco" part... But I do love Colorado!

I'm looking for a picture or two of the exterior bed support where it meets the bottom of the bed.

[commodor47]

See if the pics in my album are helpful . . .

http://www.trailmanorowners.com/foru...php?albumid=66

Keep in mind the nut on the bolt is only to keep it from falling out. It is not snugged tight as seen in one of the photos.

Dick

[usafabronco]

Those pics were exactly what I was looking for. It looks like the bottom side on my trailer is actually right. Now I'll have to check the top. Thank you!

I'm not used to seeing hardware just loose like that...