New Solar Install

[Padgett]

Know there is a thirteen page intro to solar from 2013 but want to focus a little closer.

Have been acquiring stuff for a while, have two 100W mono panels from Renogy, a basic wiring kit to join the two plust 20' of hookup, and a little PWM Controller from Amazon with a LED readout. Just a basic set.

After trying a lot of configurations, longitudinal on top of the rear module seemed best. Overhangs just a little but above anyone's head and no higher than the front modue (and shielded by it when on the road).

Does rely on that end of the TM being in the sun but does also provide some shade (three panels would be better from that standpoint). Also even if only giving 60% that would be 10 amps at 12v.

The roof seems very thin & the #10 self drillng screws did now seem to get much grip so after washing the roof, I filled the area under the mounting foot with caulk and let the screws squish. Once dried that plus the screws should hold in place.

Next step is the wiring. Right now it is just hanging down on the street side. Any uggestions for routing ? Am thnking about some channel to the bottom of the module, across to the rear arm, down the arm and over to the frame, then up through the floor. Looks like an area above the rear 12v socket that would be close to the battery and not interfere with the folding bathroom walls.

Anyone have a better suggestion ?