TrailManor Owner's Forum  

Go Back   TrailManor Owner's Forum > TrailManor Technical Discussions > How to and Modifications
Register FAQ Members List Calendar Mark Forums Read

Reply
 
Thread Tools Display Modes
Old 07-10-2003, 07:16 AM   #1
RockyMtnRay
TrailManor Master
 
Join Date: Jul 2001
Location: Colorado Springs, CO
Posts: 816
Default Using a battery charger to run the TM refer & fan

Twice this summer I've needed to make a really early morning departure and didn't want to go through the rigamarole of folding down the TM on the departure morning. Also, my TM takes up my entire driveway when setup, which necessitates my tow vehicle being parked on the street...and I'm not thrilled about doing that on the night before a big trip. So I decided to investigate whether I could fully pack-up the TM on the day before the trip...including fully loading the refer...and use a battery charger to keep the refer running over night while maintaining the TM's battery at full charge. That would also let me put the TM back in my garage and bring my tow vehicle off the street into my much safer driveway.

Since the TM refer's DC heating strip is about 100 watts, I calculated I would need a charger capable of supplying about 8 amps for that plus at least 3 or 4 more amps for residual battery charging and running the refer fan. So I went out and bought a 15/2/100 battery charger at Wally World (also available from Harbor Freight http://www.harborfreight.com/cpi/cta...emnumber=47449). The going price for these 15 amp chargers seems to be around $69. Since my TM (2720SL) has the battery in a back compartment, I decided the easiest approach would be to use the TM's existing charging circuit so I also got a 7-pin pollack receptacle ("car end&quot from an RV dealer and wired the appropriate connectors with 10 guage red and black wires. I stripped some insulation from the ends of both wires so I could clip the charger's alligator clips to them.

Before doing any testing, I set the TM up and plugged it into 120 AC for about 6 hours to cool down the refer (running on AC) and fully charge up its battery.

Once the refer was cooled to the desired temp (see my other tip on refer gadgets), I switched it to off and unplugged the TM from 120 AC. I then very carefully connected the pollack connector to the TM's umbilical cord, the charger to the wires coming out of the pollack connector, and finally the charger to 120 AC. Note: Because the red wire has 12 volts on it as soon as the umbilical and pollack connector are mated, great care has to be used to make sure it doesn't touch the black wire or the TM's frame. If you do (even momentarily), your next step will be to replace the TM's battery fuse! Judicious use of some electrical tape is recommended.

I found that with no load on the TM's battery, the charger's ammeter would show about 4 amps residual charging current. Turning on the TM's refer fan upped that to about 4.5 amps. Switching the TM's refer to DC further upped the output from the charger to between 11 and 12 amps...about what was expected and well within the charger's sustained output capability.

After disconnecting the charger and pollack connector, I finished loading the TM (including putting a bag of ice cubes and a carton of ice cream into the refer's freezer compartment), set the refer to DC and turned on the refer fan. I then folded down the TM, put it in my garage, and hooked the charger back up for the night. The next morning, I hooked up and did a 5 hour drive to the campsite. When I arrived, I found the battery was fully charged and that neither the ice cubes nor the ice cream showed any sign of melting/refreezing. Success!

A big caution: Do NOT do this if your TM's battery is not already fully charged (and capable of holding a full charge). First, the charger has very little spare capacity to charge the battery and power the refer. Second, a battery that's being charged does tend to outgas hydrogen...and one that can't be fully charged really outgasses hydrogen.

On the 2720 SL, any battery outgassing with the trailer closed goes into the interior of the rear top shell at about the rear window and will flow upward from there. Although my battery was not noticeably outgassing (about 1 bubble from any of the cells every couple of minutes),  I released the hold-downs on the front top shell after I got the TM into my garage so that it's aft end rose about a foot above the rear shell. In so doing, I ensured there would be no hydrogen trapped within the trailer. Slightly opening the rear window before closing up the TM would also probably provide sufficient ventilation for any battery outgassing from a healthy, fully charged battery.
RockyMtnRay is offline   Reply With Quote
Old 07-10-2003, 11:25 AM   #2
tipper
Guest
 
Posts: n/a
Default Re: Using a battery charger to run the TM refer &

good suggestion and detail.  I do this all the time.  Make sure you're fused somewhere between the battery just in case somthing shorts.  

With my 2720 I hook my charger through a twin banana plug installed on the battery box. [battery here is accessable on tongue].  

Similar to stated I measure 9 amps DC on the refer and 0.4 amps for the fan.  

Outgassing happens when overcharging - either at too high rate or beyond full charge condition.  Outgassing means a battery is losing water.
  Reply With Quote
Old 07-11-2003, 01:46 AM   #3
mjlaupp
Site Sponsor
 
Join Date: May 2002
Location: Downsville, Louisiana
Posts: 1,069
Default Re: Using a battery charger to run the TM refer &

Quote:
Slightly opening the rear window before closing up the TM would also probably provide sufficient ventilation for any battery outgassing from a healthy, fully charged battery.
The owners manual cautions not to tow the unit with the front or rear windows open. Could damage the window.

MJL
mjlaupp is offline   Reply With Quote
Old 07-14-2003, 01:35 AM   #4
Cateye
Cateye
 
Join Date: Dec 2002
Location: Grand Junction, Colorado
Posts: 128
Default Re: Using a battery charger to run the TM refer &

I,m confused over the need for a battery charger.
When I need to close the camper for a short period before leaving (24 hrs), I switch the refrigerator to 12V, turn on the reefer fan and plug in the camper's converter to a 115V source. Stated another way, the camper's converter is supplying 12V power to the refrigerator and reefer fan during this period. Is there a problem with this approach?
Cateye is offline   Reply With Quote
Old 07-14-2003, 04:01 AM   #5
Windbreaker
Guest
 
Posts: n/a
Default Re: Using a battery charger to run the TM refer &

The only problem is that prior to the '04 models you could not plug to 115 with the shell down. I see you have an '03, maybe they started moving the plug lower with your unit. Lucky you! 8)
  Reply With Quote
Old 07-14-2003, 05:45 AM   #6
Cateye
Cateye
 
Join Date: Dec 2002
Location: Grand Junction, Colorado
Posts: 128
Default Re: Using a battery charger to run the TM refer &

No...they did not incorporate the bumper plug in (now on 2004 though). I bought a short 3ft flat dryer extension cord that I attach to the large 30 amp cable after shoving it through the outside access hole into the storage area. The flat cable allows the top to close with interference and the large amperage rating for the extension is compatible with the 30amp rating for the campers trailer.
Cateye is offline   Reply With Quote
Old 07-14-2003, 06:01 AM   #7
Carol
Site Sponsor
 
Carol's Avatar
 
Join Date: Oct 2001
Posts: 83
Default Re: Using a battery charger to run the TM refer &

Cateye,

Thank you so much for that tip! It will allow us to close the camper down the day before we leave on a trip so we can get going bright and early.

Thank you! Thank You! Thank You!  

Carol
Carol is offline   Reply With Quote
Old 07-14-2003, 07:41 AM   #8
MawCraig
Guest
 
Posts: n/a
Default Re: Using a battery charger to run the TM refer &

Cateye,

If I'm picturing this correctly, one end of your dryer extension cord hangs below the closed camper, right?
Do you secure that loose end somehow before hitting the road?

Like Carol, I think this is a great tip!  I'm all for those bright and early departures.
  Reply With Quote
Old 07-14-2003, 07:44 AM   #9
Windbreaker
Guest
 
Posts: n/a
Default Re: Using a battery charger to run the TM refer &

Ditto, never thought of that, great idea! Take a gold star kiddo.
  Reply With Quote
Old 07-17-2003, 06:26 AM   #10
Cateye
Cateye
 
Join Date: Dec 2002
Location: Grand Junction, Colorado
Posts: 128
Default Re: Using a battery charger to run the TM refer &

the end of the dryer extension cord is secured temporarily with a wire tie to the nearby bracket
Cateye is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 05:36 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 2022 Trailmanor Owners Page.