Rear AC Ductwork

Good day all,

Our TM has a roof mounted AC unit (Emerson) located over the bed in the rear.

I have installed ductwork to move some of the AC air to the front of our TM.  I used foam attic rafter vent.  I snapped it in two to get two pieces, each about 4 feet long.  Attached it to the ceiling with velcro tabs.  It is lightweight, & can be left in place when the TM is closed.

With both pieces installed it almost reaches to the front end of the rear clamshell.  

The material I purchased happened to be beige in color, so matches the interior fairly well.

Our AC has four output vents, I closed two of them, 1 facing back & 1 facing front.  The foam channel is snug up against the front facing air vent.  I had to trim it to contour the AC unit, & also trim it around the ceiling light fixture in the hall in front of the bathroom.

It does push a considerable amount of air forward to the living area.  Will have to wait till next summer to see how well it does in hot weather.

Take care.
Dan