TrailManor Owner's Forum  

Go Back   TrailManor Owner's Forum > TrailManor information you won't find anywhere else
Register FAQ Members List Calendar Mark Forums Read

Closed Thread
 
Thread Tools Display Modes
  #1  
Old 08-27-2019, 10:22 AM
Bill's Avatar
Bill Bill is offline
Moderator
 
Join Date: Feb 2003
Location: The mountains of Scottsdale, AZ, and the beaches of Maine
Posts: 8,683
Default Roger Marble on TPMS and tire temp considerations

All -

This is an article written by Roger Marble, the Tire Guru, who is a member of this forum. I found it in a recent issue of RV Travel. Especially in light of his comments on TPMS devices, I thought it was important enough to add to the Library. He has given me his permission to copy it here to the forum.

Bill

-------------------------------------------------------------------------------------------

Tire Temperature always seems to be a hot topic

From a couple of RV forum threads.

Hot tire temperature is important but the problem is in learning what the actual temperature is.

The average temperature is not a good indicator and that is about all you can get by reading the Contained Air Temperature. While many seem to believe that their external TPM is giving them a reading of the CAT, I can tell you that the TPM will always read significantly cooler than the CAT and that the CAT is always cooler than the hottest and most critical location in the tire.

Rubber is a good insulator and does not transfer heat from the hot spots to the cooler locations very well. As a result you can have a tire failure from extreme heat in one location while another location only inches away can be perfectly OK.

I read that many TPMS have set the high temp warning point at about 158F. That is all well and good if you are measuring the actual CAT but I do not know how an external TPM will sense that temperature especially if it is out in the cooling air stream on a metal stem or at the end of an extension hose

I would always be more concerned about the pressure measurement as that is not going to be affected by cooling of the valve stem or extension hose. We know that for our purposes pressure does follow the "Ideal Gas Law" and it doesn't matter if you use air or Nitrogen the results are essentially the same unless you are measuring your pressure to the 0.1 psi.

So knowing that tire pressure will change by about 2% for each change of 10F in temperature of CAT we can get a reasonable estimate of the CAT and will note that out TPM is showing a lower temperature change than indicated by the pressure change.

I would not use the temperature reading from a TPM to set tire pressure. If I got a high temperature reading but the pressure reading was reasonable I would suspect a mechanical problem such as bearing or brake issue.

BOTTOM LINE

A motorhome properly loaded with the inflation set based on actual measured load on the tire and consulting the load Inflation tables will not result in an over-heated tire. NOTE Trailers should use different method to set pressure due to the Interply Shear issue of trailer axle alignment and should set the cold inflation to the tire sidewall pressure.

If the above isn't enough detail for you, you can review the other posts that have Temperature as part of the topic.
__________________
19 years on the Forum
19 years of TM travel experiences
2002 2720SL and 2006 2720SL
2014 Ford F-150 4WD 5.0L
Bill's Tech Stuff album
Closed Thread


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
My Discount Tire Rocks! davlin General discussion 1 07-17-2015 02:28 PM


All times are GMT -6. The time now is 08:18 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
Copyright 2018 Trailmanor Owners Page.