Mounted a flat panel tv
Using flush mount clips and a piece of 1/8" sheet metal I mounted my tv in the TM. Made custom length coax to reach to the end of the fridge cabinet .
Used spacers aka- cap nuts drilled out ) to keep the sheet metal off of the tv and room for the mounting screws and nuts for the mounting clips .
BTW... For anchoring the clips to the bath/kitchen wall I used plastic togglers to keep the screws from pulling out.
I am thinking that wall is hollow, I might even fish the cable down from the tv down to the opening near the sink then run it across through the inside of the cabinet and out again to the hookup point. Or just install another coax connector at the bottom of the wall near the sink opening.
__________________
Craig
One of the unknown ex-presidents
2008 2720SD
2008 Toyota Sienna XLE
2015 Prius v the money saver
|