I'm finally getting around to inputting the settings for my solar charge controller for my batteries. I have some questions as to what some of the values should be.
Information:
Batteries = 2x Interstate 6V XHD in serial
Solarepic MPPT Charge Controller
Boost = Absorption
Charge Controller Settings:
Over voltage disconnect voltage = ? (16.0V default)
Charging limit voltage = ? (15.0V default, thinking 15.7V due to 15.6V equalize)
Over voltage reconnect voltage = ? (15.0V default, thinking 15.7V to match limit)
Equalize Charging Voltage = 15.6V (per
Interstate Battery Charging)
Boost Charging Voltage = 15.3V (per Interstate Battery Charging)
Float charging voltage = 13.4V (per Interstate Battery Charging)
Boost reconnect charging voltage = ? (13.2V default)
Low Voltage reconnect voltage = ? (12.6V default, thinking 12.3V?)
Under voltage warning reconnect voltage = ? (12.2V default)
Under voltage warning voltage = ? (12.0V default, thinking setting to 50% or 12.14V per Interstate Battery Charging)
Low voltage disconnect voltage = ? (11.1V default, thinking to disconnect if below 25% or 11.7V per Interstate Battery Charging)
Discharge limit voltage = ? (10.6V default, thinking 11.3V per Discharge on Interstate Battery Charging)
As you can see, starting from the top and going down the voltages should be decreasing. Any help would be greatly appreciated.
Battery Charging Settings
Threaded Mode
