Door frame out of square
While opening and cleaning my new 3124KS last weekend I noticed that the lower left door frame (as you face the door from outside, the one you swing out and snap in place) was "out of square." That is, instead of the plane of the jam being 90 degrees to the wall of the TM, it slanted a little - the exterior edge of the jam being a bit slanted to the rear of the TM.
The upper part of the jam is square (and thus misaligned a bit from the lower part). The door lock and fit seem to be fine, but it doesn't look like that's how it should be. It persisted when I re-closed and opened the TM. I played a bit with positioning the shell, the snap, and the door without luck.
Do I have a problem to report to my dealer, or is this OK? Anything else to try?
|