[mjlaupp]

Originally Posted by TM_Matt

....The baggage catch looks like a great solution. It bothers me that there are two screw holes where the latch/catch would have been for the door - one at the top left of the door from the outside and one on the trailer where the door would swing to. Should I fill and paint or try to locate that original part? I will have to check with TM but I welcome any other suggestions.....

The hole in the top left of the door was where a small wheel was installed. It's primary use is to keep the sharp corner of the door from tearing the awning when one is installed and deployed. The second hole is where a small rubber bumper was installed to act as a standoff along with the door wheel when the door is open. The wheel, the rubber bumper and the baggage door latch work together to keep the door open and to keep it from marring the exterior of the TM wall. The baggage door latch is installed on the TM wall where it will catch the lower left corner of the door when it is open.
Mike