Bill, in my case, there are plenty of threads left on the adjustment bolt, but the end of the torsion bar is all of the way up against the metal sub frame. As adjusted right now, everything is OK. I am just wondering if maybe TM should have installed the next heavier set of front torsion bars on the outer shell ....maybe because of the AC unit vs. non AC weight on top?? But the outer shell back torsion bars have plenty of adjustment, so that doesn't make since either. The back pops up OK when released, but the front stays on the frame. Maybe they put heavier torsion bars on the back, but figured the front didn't need it....who knows.
To NYJeff: As said in previous posts, when the torsion bars are adjusted correctly, and the TM is level (very important), the opening of the TM doesn't take much muscle power. You can cheat a little by lowering the tongue slightly off plum to raise the front shell, and lower the bumper slightly off plum to raise the back shell.....then it would probably become a 1 handed deal.
Chap
|