TrailManor Owner's Forum - View Single Post - Help IDing interior part names for replacement

**Kidkraz** · 04-09-2023, 09:57 PM

I would pull that end piece off, remove the fabric and any foam if there is any. Lay the board on top of either luan or a thin stiff board trace it and cut it with a jig saw. If the fabric is still useable recover and reinstall. I'd measure the length of those sidewall flap seals and email the factory to see if they can shorten a seal that would go on a 2518 TM. The seals should be the same, but just differant length for each specific camper.

04-09-2023, 09:57 PM	#3
Kidkraz Site Sponsor Join Date: Mar 2013 Posts: 1,046	I would pull that end piece off, remove the fabric and any foam if there is any. Lay the board on top of either luan or a thin stiff board trace it and cut it with a jig saw. If the fabric is still useable recover and reinstall. I'd measure the length of those sidewall flap seals and email the factory to see if they can shorten a seal that would go on a 2518 TM. The seals should be the same, but just differant length for each specific camper. __________________ 2013 2619 80 watt solar panel/swing hitch/low profile A/C. Enduro 4445 caravan mover 2016 Dodge Ram 1500 V8 Hemi Installed powered folding tow mirrors Stopped playing with airplanes, now I just enjoy watching them fly by.