[ShrimpBurrito]

BTW, I think the front of the front shell is now where is should be because the ~6" swing-out aluminum stabilizing arms that brace the lower part of the trailer to the shell now are at a 90 degree angle when fully swung out. Before, they would not swing out far enough to fully seat the pin in the shell.

I just looked on the inside of the front shell where I had wear marks on the ceiling from the seal on the rear shell, and it seems I already have started to wear in a new spot. But while the catches for the white corner latches on the outside only moved forward about 1/2", the new wear spot is probably 4-5" behind the old one!

ARGH! This is driving me crazy.

Dave