Quote:
Originally Posted by Larryjb
OK, this give me an idea, perhaps. Use a bottle hydraulic jack + 2x4 notched to fit in the bottom of the shell. I can then zip tie the 2x4 to the lift arm to keep it from falling away.
|
No need for any notching, and you don't want the 2x4 that close to the lift arm - it would be in the way of accessing the bolts. Unless you like the idea of a quarter turn at a time on a bolt.... And you want the 2x4 perpendicular to the bottom of the upper shell, not "in the bottom" of the shell. Just in case you actually meant to put the end of the 2x4 up inside the shell..... the 2" sides should be towards the TM wall and facing out, the 4" sides should be facing forward and back. I suppose you could make a slight notch for the entire width of the shell wall to sit down into the end of the 2x4 a small amount though.
Quote:
Originally Posted by Larryjb
There's always something....
|
Yup, there is. Just like with a house.....