Raising Rear of Front Shell
I need to replace the wood bow on the upper back edge of the front shell and replace the bag seal all the way around. Is there some info on lifting the rear of the shell so it clears the back. I only need about a 4" lift and assumed you detach the rear shell from the rear torsion arm and then lift it to clear with the front arms intact. Any suggestions would be helpful. I will remove the a/c pedestal as some spread a few tubes of sealant around it to try and stop the water leak created by the sagging roof edge. I plan to clean it up and then re-bed the pedestal in a moderate amount sealant, What sealant would you folks recommend?
|