TrailManor Owner's Forum - View Single Post - Replace Thetford w/Sealand 711-M28C?

thewayneo · 06-16-2012, 01:47 PM

Here are some early pics of the Sealand toilet install:

First is moving (wallowing?) the existing hole in the floor. When you install the stock factory tank it won't look quite this bad! I used a longer than normal jig saw blade. Real easy cut.

Next shows the ABS fitting that screws into the bottom of the tank. The stock factory tank will have the fitting closer to the rounded end of the thicker material.

3rd is toilet installed with lid up.

4th bowl and positive seal.

5th lid down. The little square thing at the back is a vacuum breaker safety device.

06-16-2012, 01:47 PM	#24
thewayneo Senior Member Join Date: May 2010 Location: Evergreen, Colorado. Halfway between Heaven and Paradise at 8,100 ft altitude. Posts: 111	sealand pics Here are some early pics of the Sealand toilet install: First is moving (wallowing?) the existing hole in the floor. When you install the stock factory tank it won't look quite this bad! I used a longer than normal jig saw blade. Real easy cut. Next shows the ABS fitting that screws into the bottom of the tank. The stock factory tank will have the fitting closer to the rounded end of the thicker material. 3rd is toilet installed with lid up. 4th bowl and positive seal. 5th lid down. The little square thing at the back is a vacuum breaker safety device. Attached Thumbnails __________________ 2006 2619, with REAL Flush Toilet (Sealand), NEVER ANY HOOKUPS!!! Five-inch lift, Goodyear Marathon 15" Made in USA! 2005 Ford Explorer V8 -- WDH w/active sway 1973 Moto Guzzi V-twin