Hi all,
In another
thread I posed the question "How do you properly adjust the Brake Controller?"
I have a Prodigy controller and here are the steps from the Prodigy manual:
Quote:
1. Connect trailer to tow vehicle.
2. With engine running hold manual full left and set
Power Knob to indicate 6.0
3. Drive tow vehicle and trailer on a dry level paved
surface at 25 mph and fully apply manual knob.
✓ If trailer brakes lock up:
❑ Turn power down using power knob.
✓ If braking was not sufficient:
❑ Turn power up using power knob.
4. Repeat Step (3) until power has been set to a point
just below wheel lock up or at a sufficient force as
to achieve maximum braking power.
5. Using the brake pedal, make a few low speed
stops to check the power setting. Trailer braking is
initiated and terminated via the stoplight switch.
When the brake pedal is released, trailer braking
will cease.
|
As I stated in the other thread it is near impossible to lock the wheels on the TM.
Rick said:
Quote:
|
go until you feel the Trailer "pulling your TV backwards" with just a moderate amount of "extra" braking power in comparison to the TV stopping all by itself ... and don't push the power adjustment any further.
|
Now I am not new to driving or pulling trailers, but I find it hard to know when I have the power set correctly on the Prodigy Controller.
So the question is, how do you adjust your controller? Is there a proven way, or do we all just have to guess; then hope and pray we have it right?
Thanks, Keith