[S&C-Nevada]

Hello, I have a 2002 2720 SL. Trailer was derelict in vacant lot when I bought it from an older couple. I've been working on it as time permits. The question I have is about the tongue jack. It is a sidewind jack. The decal is illegible, but I presume from reading this forum that it is an Atwood 1000 lb jack. Yesterday I was installing an Anderson weight distribution hitch. Installation instructions call for lifting the front of trailer and rear of tow vehicle to the "at rest" bumper height. In doing so, I believe that I've put too much load on the jack and stripped the gears of the jack. Is there a replacement gear kit available? I believe that I've found the correct part number, Kit #25524, but I can't find a seller. Alternatively, I've looked at replacing the jack. I've found a Dutton-Lainson jack with a 2-inch diameter with 1000 lb capacity. Are there any 2-inch diameter jacks with a capacity greater than 1000 lb? Thanks for your help. SCR