View Single Post
Old 01-28-2010, 04:07 PM   #7
PopBeavers
Guest
 
Posts: n/a
Default

Quote:
Originally Posted by Scott O View Post
Regarding the WDH, you may or may not need one. Do the following: Measure carefully the distance from the fender bottom center on a front and back wheel, to the ground, same side. Then attach the TM and remeasure. If the front goes up and the back goes down you need a WDH. A properly adjusted WDH will allow the front and rear to sag the same amount. Problem with having the front go up is that you will be decreasing steering and braking. There is a primer on this forum if someone will point you to it.
Fwiw, with my 2002 Silverado 4x4 6.5 foot bed attaching the TM 2720 causes the rear bumper to sag about 5/8 inch. I do not use WDH. I did not measure the lift in the front.

I would not be concerned about a slight sag. I would be surprised to find zero sag. Mine will sag if I stand on the bumper (200 pounds), but not much.
  Reply With Quote