[Padgett]

I replaced mine with a Fiamma F45s which is a newer design and does not stick out as far as the original F45i but is the same size awning.

It came with three brackets and each bracket has a channel at the top to hold the awning and a screw/nut on the bottom of each to retain the awning. Remove the three screws and the whole awning can flip on top of the TM for minimum width but really does not stick out much more than the patio lights.

I did redesign the TM mount (lotsa #6 screws) with a 4 foot 1/8 aluminum "L" from HD cut into three pieces: 2 18" ends and a 12" center. Then used 12 1" #12 SS sheet metal drilling screws on each end and 9 in the middle with three in a triangle through each bracket. Screws are through both cap and wall. Not going anywhere.

Someone mentioned that pop rivets work as well or better but prefer to be removable.

ps the Fiamma instructions say to center the "support" label on the bracket. Don't.