Quote:
Originally Posted by coralcruze
people smarter than I am on this board recommended 300 Ft lb. and using double nuts to lock in place but you may opt to weld it back to the frame. that work also.
|
If you tighten to 300#, you'd better use crush sleeves inside the square spacer. 300# will likely stretch those bolts. I would be concerned about the bolts snapping. Be sure to use grade 8 bolts if you are torqueing that much.
Double nutting is OK too but I would also use the Red Loctite #271.
https://www.amazon.com/Loctite-Threa...s%2C132&sr=8-2