Quote:
Originally Posted by CAmark
Only experienced one time when the bed would not slide back in...the washer that rides on the plastic strip had gotten between the plastic strip and the bottom of the bed-pan (for lack of a better word?)...gentle coaxing righted the situation and have not had the problem again.
mark
|
Thank you Mark,
I order from factory what I thought was the inside sliding track when opening and closing the bed. Instead they sent me the plastic strips. I did notice the last time I close up that it look like the plastic was a bit cock eye. I will make it a priority to check the next time I open it up.
Thanks a million for you insight
Hope to see you the both of you at the rally in October.
Joe