Thread: Heater gas hose
View Single Post
Old 10-16-2007, 05:25 PM   #2
Scott O
Guest
 
Posts: n/a
Default

Replace the hose (or maybe splice in a new section?) and make sure it is routed so the shell does not pinch it on top of the frame. There might be a rubber pad on top of each side of the 'a' frame where the shell rests. Make sure nothing is between the shell and either the pad or the frame. When we first got our TM I rerouted some hoses and wires in a much more efficient manner than it came from the factory. When I closed the shell I discovered why they were routed that way in the first place and put eveything back as it was!
  Reply With Quote