Quote:
Originally Posted by rickst29
I'll SWAG that inverting the shank and using "appropriate" holes for the TM A-frame height will leave plenty of room, but there's a chance that you may need to add the lift kit (if it isn't already there) to get sufficient height underneath the A-frame arms.
|
Alright... I'm convinced
That makes sense. I can raise the height of the ball mount on the shank and bring the bars up off the ground. So, I think I'm going to go with the E-Z Lift 48053 or 48052 that you referenced earlier.
One more question... should I go with the 800# or 1000# model? I realize that the tongue weight is closer to the 800# model, but should I go a bit bigger to the 1000# just to be safe? One more thought... will the 800# version allow me to use fewer links in the chain and raise the bars a bit higher?
Sorry for all the questions. I sincerely appreciate the willingness of everyone to help in this forum. It's pretty amazing and I'm glad I subscribed!
Kurt