Quote:
Originally Posted by Bill
Larry -
If you look at them closely, you'll find that the screw heads have square sockets, with a bit of a slot cut out of each corner. This means that a Phillips screwdriver will work, but only if the screw is not really very tight. If you run into a tight one (and admittedly they are few), a Phillips driver will strip it out.
A set of square drive drivers (I think there are 3 sizes in a common set) costs only a few bucks. I'm thinking less than $5 from someplace like Harbor Freight, and maybe $10 from Ace Hardware. In my opinion, it is worthwhile. A stripped screw is an instant problem.
Bill
|
You sure hit the nail on the head, Bill. I do find the proper connector easier to use, once I identified which one it was.
Thanks,