View Single Post
Old 05-18-2008, 06:02 PM   #3
agesilaus
Guest
 
Posts: n/a
Default

We just got a P3 when we bought our 2619. Our truck also was prewired so there was nothing much to the installation, drill two small holes for the self tapping screws for the mount, plug it in and that was it. Make sure you pick a spot that you can see the display. Ours is mounted to the right of the steering column, low with it pointing more or less up. Down near your leg.

I had to move it over 3 inches so I could see it better without the steering wheel being in the way.

If you had to wire it yourself then there would be a lot more work, you'd have to identify which wires to tap into in that mares nest under the dash.

BK
  Reply With Quote