Quote:
Originally Posted by ShrimpBurrito
My question here was more about where to install an ATF temperature probe somewhere in the tranny system myself if I cannot get Scangauge or the Interceptor to read it off the OBD bus. To do this, I'd have either drill a hole in the tranny pan and screw in a sensor, or cut out a piece of ATF line to install an inline sensor, and then run a wire from this sensor to a display unit in the cab. That's the only way I know how to get ATF temp if that's the case.
Dave
|
Dave - Go way back to the beginning of the board - 2002? - and look for posts by RockyMtnRay on the topic. To the best of my memory, he did the first installation of a "real" sensor and gauge on this board, and ran into a problem finding a shop to do the work. But he ended up with a lot of knowledge, and a good setup.
I will look for the original thread - it may be lost in the archives. A followup is here.
http://www.trailmanorowners.com/foru...ead.php?t=2900
Bill