Quote:
Originally Posted by ShrimpBurrito
So if that's the whole purpose of the baffles, I wonder then if they can be avoided simply by using a louvered vent (like what you used in the center on the outside, which I presume was simply the one installed by the factory) that is larger, wide enough to cover your enlarged hole. Obviously, it would have to be sourced, but there may be something out there suitable. Dimensions wouldn't have to be exact. The height could be a little bigger of course, and the width could vary as the size of the enlarged hole probably has some flexibility (in terms of making it slightly smaller, if necessary).
Dave
|
It's not the original louvered vent. I purposely had the large center one point down and the outer vents point off to the side so that the intake vents (side) wouldn't take in hot air that is being exhausted out the center vent.