I got my Andersen WDH today and sure enough I will need the extra plates as well. I went ahead and attached the two plates and the tension plate on the drivers side. I tightened to 90lbs and the frame did not seem to mind at all. When I order the other two plates tomorrow, I will ask if it is fine to put a self tapping bolt through the same set screw holes and into the frame.. This should keep them from sliding forward. On the door side where is the bracket for the swing away hitch. I checked clearance for the brackets and brackets just clear where it attaches to the frame. The break away cables will be able to be reattached into the same holes after the WDH install. I absolutely hate the break away cables that came with the TM. They are so hard to work with and attach. Mark, thanks so much for the help. I also checked the axel today and everything seems good.
|