I am certainly not as expert as many on this forum, especially in the use of a WDH. Are you getting the back end sink while using the WDH? If so, then I would think it is not adjusted properly. If the rear of the TV sinks without the WDH, this would probably be what you would expect. As I understand it, the WDH is designed to take weight from the TV rear and distribute it to the trailer tires and to the front end of the TV, keeping your TV level. Get a ruler and measure from the ground to the center of the fender on both the front and back wheel of the TV when unhitched. When hitched, using the WDH, measure again. If the front and back of the TV did not sag approximately the same amount, then you have a WDH adjustment issue.
|