Quote:
Originally Posted by CAmark
I'll chip in the 90 degree elbow on the city water inlet...stops the rear shell very nicely. The elbow now stays on the hose when we have hook ups so I don't make that mistake again.
|
I read about this happening to someone in a previous thread and it actually ripped up the inside wall of the upper shell. I was so afraid of doing this that I used a couple of wrenches to tighten up the hose to the elbow so it can no longer be separated by hand.
__________________
TV: 2002 Toyota Tundra Acess Cab, TRD, 4WD, LS, Tow Package.
Mods: 7-pin Connector, Tekonsha P3, Reese WDH, Milenco Grand Aeros, Leer cap, FS airbags, RVS backup cam & monitor, front hitch.
TM: 2008 2619, A/C, Swing Tongue, 40 gal Tank, Awning, Cabinet over sink, MW drawer.
Mods: Kumho 875 205/R14s, Shower curtain & Oxygenics, Sewer hose stow, Prop reg on top, (2) Trojan 27TMs w/1+2 switch, Marinco A/C plug, RVS backup cam, Honda EU2000i & companion w/extended run tank.
|