TrailManor Owner's Forum - View Single Post

LoveToCamp · 04-10-2012, 12:10 PM

Factory: An additional flat, fairly-large storage space could be utilized above the refrigerator, if, instead of sealing the facia above the 'fridge, the panel (about 5" x 22", I believe) was put on a couple of inward-opening hinges. Yes, the inward opening would reduce the size of the storage space, bit it would retain the clean trim look. Or, it could be an outward-opening cover, but that would take a little more trim to finish the edges of the "door".

Also, the drawers are about 4" shorter than they could be. If they were 4" longer, you could still get them out of the drawer bay, so that is not the issue.

Finally, have the assemblers pay a bit more attention to detail. The latches on the beds don't align with the receiver holes very well. I simply plugged the old screwholes, and re-mounted the latches, and they work smoothly. Simple attention to detail during assembly. If the latches are not put on in-place, but mounted before the bed is inserted, that is an issue. May just need to change the assembly method.

04-10-2012, 12:10 PM	#1
LoveToCamp TrailManor Master Join Date: Apr 2012 Location: Centennial, Colorado Posts: 886	Additional storage in 2417 Factory: An additional flat, fairly-large storage space could be utilized above the refrigerator, if, instead of sealing the facia above the 'fridge, the panel (about 5" x 22", I believe) was put on a couple of inward-opening hinges. Yes, the inward opening would reduce the size of the storage space, bit it would retain the clean trim look. Or, it could be an outward-opening cover, but that would take a little more trim to finish the edges of the "door". Also, the drawers are about 4" shorter than they could be. If they were 4" longer, you could still get them out of the drawer bay, so that is not the issue. Finally, have the assemblers pay a bit more attention to detail. The latches on the beds don't align with the receiver holes very well. I simply plugged the old screwholes, and re-mounted the latches, and they work smoothly. Simple attention to detail during assembly. If the latches are not put on in-place, but mounted before the bed is inserted, that is an issue. May just need to change the assembly method.