Door mismatch
Hi All,
Have you tried to raise the front of the front shell to fix the rear part of the front shell binding? This is part of the shell alignment procedure - you measure the distance from the bottom of the base/box up to thr inside of the pocket where the arm bends. In my case it measured 39 1/2 inches on all four arms. How does yours look? All the same or differant ? Then check the rear shell, it should be somewhere in the 38 to 38 1/2 range. I do know in this forum is a laid out step by step procedure on how to level the shells.
Good Luck
Bob
|