Phil,
When I had a boat trailer axle that wasn't straight I measured from the center of the tongue coupler to where the axle attached to the frame on each side. I used the front edge of the axle. Jacked up the frame and moved the side that was to far back forward. I think there was thread on the forums about doing that? Something similar may work for you using before and after measurements.
__________________
Axis 24.1 E 450 chassis, 6 spd tranny. GVWR 14500# GVCWR 22000 # GW(scales) 12400 #
[SIGPIC][/SIGPIC]
mods: 2- 100 watt solar panels, on roof, 300 watts portable
“They who would give up essential Liberty, to purchase a little temporary Safety, deserve neither Liberty nor Safety.” Benjamin Franklin
|