Hello,
I got my directions out of my TV so I may be able to help. First of all I have a Husky wd. What make is yours because the odds are someone on this forum has your model. Anyway my wd has 4 harden steel washers. It says to place all four on the pin to start out but the number of washers may have to be changed in the next step. In the next step it said to rotate the head forward as far as it will go. Ball should be vertical or tilted slightly back. If it is not, change the number of washers on the pin and reassemble as before. If you PM I will send you a scan copy of my directions. Just for reference in the Trailblazer I owned I installed the 4 washers but the head was not vertical and I had a hard time disconnecting the TM. I removed a washer and reassemble the unit and had not trouble. Well I traded that in for a new Chevy Silverado and had to put the washer back in to get the proper angle. Hope this help out.
|