Quote:
|
Originally Posted by Caver
Let us know how it goes. I ground about 1/8 th inch off the pin based on what I read here and had to move the disconnect switch a few inches. It's worked fine.
I use my electric tongue jack to make it easy to connect the bars.
Ray
|
I would appreciate pic's from anyone with an "Equal-I-zer" hitch and the folding tongue. I cut -off 1" of my bars to install and then the bottom of the "pin" for the swing tongue hinge is right at the height the bars need to go for "proper" adjustment. I am going down the road leaning a little to the rear now. There is not that much to grind-off this hinge pin without losing it altogether it appears.