I have included 3 pictures.
One shows the broken flange caused by the screw
One is just a top picture of the drainpipe
One shows the back side of the drainpipe raised about 1/2". It tapers to flat on the floor towards the front Bath door side.
I have tried just pushing hard and the drainpipe does not push down at all.
I have crawled underneath, and nothing is broken. I also tried pulling down on the drainpipe and it does not move much at all.
I had shims. Mine very made from the same material as the floor but they were stapled down. However, I only had two in the back and the locator disk in front on the side closest to the sink. There was no shim in front the tube side. That could be why the toilet always rocked a little.
|