View Full Version : Looking at a 1993 model 3326 King

06-29-2008, 11:28 PM
I've been shopping around for a used travel trailer, and the one on top of my short list is a 93 3326 that I have come across. I have not inspected it yet and was hoping some of you veterans would give me any ideas as to what areas I should be looking at for potential problems of if there are any known issues with these trailers that I should be aware of. Seller says everything works on it, I will see on Tuesday when I view it.

Also, what key changes have been made between the 93 models and the current ones I've looked at on this site, other than the wheel well improvements? Do TrailManors hold up well if lived in long term, if anyone has had any experience with that.

I'm fairly new to the RV scene, and glad that there is an active community for owners willing to share info and help others out. I've already learned more browsing these forums than I have in the sum of the rest of my research. I look forward to joining and contributing to the community.

Seriously, the helpful and satisfied owners on this forum already have me convinced that this is THE brand to own.

Hopefully, if this trailer I'm considering isn't a basketcase on inspection, I will be a proud owner myself.

Oh BTW tow vehicle will either be a 92 dodge half-ton with a Magnum 318 and a 5 speed or an 07 Silverado 1500 4.8 auto, so either truck should tow this thing with no sweat at all.

06-30-2008, 06:37 AM
There have been a number of improvements since 1993, but none are critical to your enjoyment, and many can be retrofitted if you decide to do so.

The big issue to watch out for in a trailer this old is this. In that era, the shells (the upper parts that lift up and out when you set up the trailer) were framed with wood. On more than one occasion, an owner allowed water to get inside the walls, and the wood rotted. As a result, it won't hold screws, and the body panels tend to separate at the seams. The wood can be replaced with aluminum, but it is not an easy job.

To discover whether or not your particular TM has this problem, first look at all the places where sidewalls meet the endwalls, and where the walls meet the roof. Is there any sign that the panels are pulling apart? Does the caulking all seem tight and well-adhered? Examine the seams inside and outside - on the insides particularly, do you see any signs that it has been wet?

Now back out some of the screws out of the lower edge of the shells. Do this in several different places around the perimeter. As you remove each screw, look at the threads - are there any rotted wood crumbs sticking to it? Shine a flashlight up into the screw hole. Do you see solid wood, or rot? Poke a long nail up into the hole - does it hit solid wood, or push through mushy stuff?

The screws along the bottom edge of the shells are reasonably easy to get at - you may have to remove some trim. But the rot problem can also occur where the sidewalls meet the roof, but I don't know how to get access to any screws there.

There have been a number of threads about rotted frames on this board. With some searching, you should be able to turn them up. I don't mean to scare you, but a particularly nasty story from this board (now archived) appears at


Close inspection of the unit's wall-to-roof seams, from the inside and outside, is probably your best assurance that your TM is a good one.