Glenn in TN
06-11-2005, 12:28 PM
The table in our 97 2619 has problems.
1.) The small tabs that are under the sections were very flimsy when they were all unstalled and working. Now most are missing and the ones that remain are bent. Has anyone done anything that would beef up this? What kind of screws are needed to reattach something beefier to the thin veneer and foam core?
2.) I the middle of all this, a corner of the front section is chipped off. What if anything could be used to reattach this?
1.) The small tabs that are under the sections were very flimsy when they were all unstalled and working. Now most are missing and the ones that remain are bent. Has anyone done anything that would beef up this? What kind of screws are needed to reattach something beefier to the thin veneer and foam core?
2.) I the middle of all this, a corner of the front section is chipped off. What if anything could be used to reattach this?