Bob (
bheisser) your replacement couch looks promising. I have looked at etrailers site and am unsure what you purchased (a link would be appreciated). I don’t see anything with armrests.
I COVERED THE EXISTING WITH MATERIAL FROM PAT CATANS FABRIC,,I ALSO COVERED THE BASE, HAD TO TAKE BASE APART
Would you consider it comfortable or just better than what was there?
BETTER THAN WHAT WAS THERE, MY WIFE SAYS IT IS COMFORTABLE,, I AM USSUALLY OUTSIDE
How difficult was the instillation?
I AM PRETTY HANDY INSTALLED ON EXISTING HARDWARE SO I HAD To REMOVE THE OLD COUCH, REMOVE ANGLE IRON AND USE A CUTOFF TOOL TO CUT OFF THE RAISED WELDS FOR THE EXISTING COUCH, PUT ANGLE IRON BACK, THEN SET THE COUCH IN PLACE AND MARK HOLES,, DRILL HOLES (YOU WILL NEED A GOOD BIT)
RECOVERED FABRIC...
PROBABLY TOOK M.E 6-8 HOURS TOTAL
Did you purchase a stand along couch I or just the seat and b,ack and use existing TM storage box to put it on? EXISTING, BUT IT MAY BE EASIER TO BUY THE LEG KIT AND JUST REMOVE THE FACIA PIECE WHEN U WANT TO USE THE FURNACE
Were you able to keep the storage under the couch?
YES, BUT IT IS A LITTLE TIGHTER TO GET STUFF IN AND OUT
We have fold out tables in front of the couch. Did you have to remove them to make this fit?[/QUOTE]
YES IT WOULD BE HARD TO PUT THEM BACK IN, THE COUCH COME OUT TO FAR
https://www.etrailer.com/RV-Furnitur...95-000013.html
Hybrid Mode
