Bed supports

Does anyone know if the flange on the bed support bushing goes on the inside or outside?

http://i249.photobucket.com/albums/g...IMG_1242-1.jpg

[ZekenSpider]

Larry;

Look at the posts at:
http://www.trailmanorowners.com/foru...ead.php?t=8662
and at:
http://www.trailmanorowners.com/foru...ead.php?t=9345
with photos at:
http://www.trailmanorowners.com/foru...php?albumid=66

The TM 2006 "Weekend Getaway" brochure front page also has a good picture of the spacer.

Jerry

Thanks Jerry.. I was wondering if the nuts were suppose to be loose like the pix too. When I got my TM they were loose so I tightened them up snug and the first time I used it after that the supports came out of the tracks.

[Wavery]

Originally Posted by Larry Gault

Thanks Jerry.. I was wondering if the nuts were suppose to be loose like the pix too. When I got my TM they were loose so I tightened them up snug and the first time I used it after that the supports came out of the tracks.

There should be a little space for the arms to slide freely down the track (~1/8" I would guess). It also helps if you take those slotted, plastic tracks off and clean them. Then spray a little silicone spray on a rag, wipe them down and reinstall them. Then, once in a while, wipe them off with a rag with silicone on it.

If you "Grease" the slide with anything, it will pick up all kinds of dirt.

Noticed that the bed sags through over the propane tanks. Temporary supported during sleep with plywood and a 2x4 as a brace.
Any suggestions on a more permanent fix? Is this a TM dealer isse?