Quote:
Originally Posted by makriegz
@larsdennert, I'm loving your take on shark biting into the water supply. Any additional pics or tips you could include would be much appreciated. Same for the vent out - I wasn't aware that the sink already has a vent out. I found a great diagram of the supply side ( https://www.trailmanorowners.com/for...ad.php?t=21050), but looking under the cabinet it's hard to tell which is which.
I haven't yet found a schematic for the drain side. It sounds like there, I will need to do some research on how to use ABS glue and ABS shavings to re-seal to the gray tank, and then fill in with standard sewer drain parts.
|
I don't think that the sink has a "Vent out". That sink itself supplies all the air necessary for venting the drain. I could be wrong but it makes no sense.
The water supply "SharkBite T" is easiest installed in the water supply line going to the kitchen faucet cold water line, under the kitchen sink (where there is adequate room to work) then routed over the top of the water heater, through the bathroom cabinet and exiting next to the toilet. It's a straight shot.