Thanks a lot for your reply, yes turning signal and running light is working.
And I found that 7 pin circuits for Jayco is different from TM’s circuit pin arrangement.
Jayco’s circuits arrangement are, from 1 o’clock, Marker, Left turn, Ground, Brake control, Right turn, Brake light and backup light in the center.
As you might have noticed, not like TM, Brake control and Brake light is separated and 12V charge cable in in Jayco’s brake light position.
I think this caused problem but I don’t know why the back up light(which is in the same position with Jayco’s) is not working.
Could you figure out what would be the problem with the information above?
Any opinion will be highly appreciated.
Thank you
Martin
|