Quote:
Originally Posted by Redhawk
I'm mainly concerned with the upholstry part of it. What did you do with the fabric?
|
Once I figured out where to put the vent, I marked the four corners and used a razor to cut the fabric.
Made four cuts, one from each corner to the centre, or similar. No fabric was cut out.
Then folded the fabric wedges out of the way and cut the panel (with the razor too IIRC).
Then the fabric wedges can be pushed into the hole and folded around the edges, trimmed if necessary, and the vent inserted.
I forget how the vent is attached, maybe it was just a tight fit?