I am working on a project that required pulling the sink. As long as I am in there I am installing a accumulator tank also.
Now I am considering ThePair’s “bridge”. I am a bit confused and having problems finding parts. I am considering buying the PEX crimping tool as with the combination of projects it might pay to go that way rather than shark bite and flair-it fittings. Here is some of what is puzzling me.
I am not sure what route the water flows to go from the pump to the holding tank or when used to fill using the female coupler to the high-pressure drain. Part of the problem I think is I don’t fully understand where the valves direct the water.
Are the valves 3 way valves?
Where can you get the flair-it fitting? (I looked at home depot and on line but only found 10 packs on line.)
How did ThePair add a female coupler to the high-pressure drain?
Has ThePair had any problems after instillation?
Has anyone else done this that might have suggestions or comments?
__________________
Roger and Patty
TM:2006 2720SL
TV: 2010 Tundra w/ tow pac.
Dealer Options:swing tongue, sink cabinet, awning, air conditioning, tile
Modification: 15“ tires & monitor system, WDH, Prodigy B.C., 2-6 V. batteries & clipper monitor, LED's. Additional modifications can be seen in albums.
Pictures of campsites and places we visited can be seen at https://www.flickr.com/photos/101899116@N06/sets/.
|