The plates themself are not thick enough to properly support the round ends of the shelves. Not deep enough. If they were think plates they would interfer with the folding of the bathroom walls and the closing of the trailer.The plates strenthen the small mount holes in the walls themself. I wanted the shelves to hold a decent amount of weight. The left side bathroom wall is thin wall board and the right or trailer side wall is aluminum. Not strong enough to support weight without becoming oblong over time.
Look close at the bottom shelf. Only one side needed to be supported into the wall. the other side rests firmly on the trailer railing. Simply lift that side up and it comes right out of the mount holes on the other side. The top shelf needed to be supported on both sides and YES! when unlatched the wall flexes way more than enough to allow for the easy installation or removale of the top shelf.
|