I'm about to do my EZ-Lubes again, as we prepare to leave Maine for Arizona. Having learned from the last couple times, and after discussion with MikeD about his Nev-R-Fails, I think that this time I am going to pop off the little sheet metal hub cover before I connect the grease gun. It's just a friction fit, and should come off fairly easily if I tunk it with a piece of wood. With the cover off, it will be a lot easier to see what I am doing, get the old grease off the hub, avoid cut fingers, and avoid grease splats all over the wheel as we travel. If anything goes wrong with this approach, I'll post - but I think it will be a big improvement.
Bill
|