[Shane826]

I don’t think this is a torsion bar adjustment issue. Is there a broken bar or did one of the brackets pull out of the floor?

Maybe it’s just me and I’m way off, and I keep forgetting to look at mine for comparison, but the lift arm looks kinda low on the torsion bar (see pic), like it dropped down while the camper was set up. Unequal length lift arms cause all kinds of binding and flexing issues.

Open it back up, stick your tape measure up into the pocket against the “L” of the lift arm, and measure right down to the bottom of the lower box. Front shell arms should be 39-1/2”, rear shell arms should be 39”.