TrailManor Owner's Forum - View Single Post

Gocntry · 06-09-2018, 04:23 PM

I might have an issue with a lift arm, Or it's just me I dunno

On the front arm of the rear shell / door side

The door side corner of the rear shell doesn't seem to quite fit tight against the upper shell bag seal, 1" to 2" gap, I can get it to close up with a little work

I can wiggle the lift arm when the TM is set up (like wiggle slightly, not move it around inches) Can't wiggle the others though.

The lift arm is not broken. welds look fine up in the pocket

It does look like the lift arm is sitting lower on the torsion bar that the other arms are.

Do I need to loosen the 4 bolts get the shell tight to the bag seal and re-tighten the bolts? Lifting the are will make it tight again, could it have slipped down a little?

Torsion arm is OK too, nothing broke under the TM

Any thoughts or suggestions welcome

Thanks

Jeff

06-09-2018, 04:23 PM	#1
Gocntry New Member Join Date: May 2018 Posts: 1	Lift Arm Issue?? I might have an issue with a lift arm, Or it's just me I dunno On the front arm of the rear shell / door side The door side corner of the rear shell doesn't seem to quite fit tight against the upper shell bag seal, 1" to 2" gap, I can get it to close up with a little work I can wiggle the lift arm when the TM is set up (like wiggle slightly, not move it around inches) Can't wiggle the others though. The lift arm is not broken. welds look fine up in the pocket It does look like the lift arm is sitting lower on the torsion bar that the other arms are. Do I need to loosen the 4 bolts get the shell tight to the bag seal and re-tighten the bolts? Lifting the are will make it tight again, could it have slipped down a little? Torsion arm is OK too, nothing broke under the TM Any thoughts or suggestions welcome Thanks Jeff